Professional Heavy Duty

Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger

Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger
Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger
Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger
Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger
Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger
Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger

Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger    Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger
Telescopic Heavy duty slingshot rifle. By lengthening the slingshot rod to increase the firing speed and firing distance, the extended firing speed can reach 150 meters per second , maximum firing range can reach more than 200. Heavy duty slingshot rifle installation. Install the bow head: First, find the two thickest black screws and two nuts in the accessories bag, insert the screws into the holes and then put on the nuts, as shown in the picture. Please note that (because the nuts are embedded in the rubber pad, you need to use tools to fix the nuts to tighten the screws).

Install the release device: Find four black screws of the same length and insert the release device into the reserved hole of the rod body as shown in the figure. Install the laser base: First find the two longest white screws and two nuts, please note (the two nuts do not match the screws, just used to raise the height of the laser base, if you think the height is still not can use other heightening objects instead). Install the rear handle: first find two yellow screws with the same length (no nut is required), as shown in the figure: insert hole 1 and hole 2, and then tighten them with force.

As shown in the picture: Clamp the second segment of the back handle into the first segment, align with the screw hole, find the small yellow screw and the small nut, screw through the round hole side, nut through the corner side, and tighten. As shown in the picture: first find a short white screw, connect it to the handle, and then find two thick yellow screws (no nut required) to insert from the unthreaded side, and then tighten. As shown in the picture: Insert the last section of the rear handle, and insert it forcefully (no screws required). Install the laser track tube.

As shown in the picture: First loosen the screw of the laser tracking tube, fasten one edge of the support frame, press the track tube with your thumb and push it to the other side.


Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger    Heavy Duty Slingshot Rifle Professional Hunting Slingshot Pull The Trigger